Sper Scientific ELSEC765 Environmental Monitor
Ultraviolet, Visible Light, Humidity and Temperature Meter
This single environmental instrument enables measurement of the four parameters that cause most damage to buildings, valuable objects, documents etc: ultra-violet and visible light, humidity and temperature.
For many years it has been recognized that one of the major causes of damage to museum objects and other antiquities is the fading and rotting effect of light on the object. The most damaging part of the illumination is its ultraviolet (UV) content. Since 1976 Littlemore Scientific (ELSEC) has been providing instruments that enable the conservator to measure the UV content of light and thereby protect valuable exhibits. Using the 765, measurements can be taken of the proportion of UV present (mW/lumen), the total amount of UV (mW/M²), the amount of visible light present as Lux or Foot-candles. Temperature can be measured in °C or °F, humidity is shown as % Relative Humidity (%RH) and dew point. The displayed units can easily be changed by the user.
Provision is made for user calibration of the RH sensor using saturated salt solutions.
A calibration kit is available as an optional extra.
Min/max values and their time of measurement are displayed for each parameter.
Anyone can take measurements straight out of the box with little, if any, reference to the instruction manual. The appropriate button is pushed depending on the measurement required and the reading is taken. The unit automatically turns off 10 seconds after the last reading unless a button is held down for over 5 seconds, this causes continuous measurements to be taken until another button is pressed. The large 8 line display enables an easy to use menu system to select the more advanced functions, change units etc.
Units of measurement for UV
Traditionally UV has been measured in museums as the proportion of ultraviolet present. This result is useful for checking a particular lamp or window because the proportion of UV does not change with the distance from the light source. Using a simple rule, the amount of UV on an object can be limited (it is usual to arrange that the proportion of UV should not exceed 75mW/lumen in museums). The actual amount of damage done is determined by the total amount of UV falling on the object, so it is useful to be able to measure this directly, especially if non standard amounts of illumination are required. The amount of UV should be as little as possible but in general should not exceed 20mW/M².
A Lux readout is provided to control illumination and limit damage done by visible light. Normal museum light levels should be limited to 150-250 Lux.
Dimensions: 5.9" x 2.5" x 1" (150 x 65 x 25 mm) including RH/Temperature probe
Weight: 5.6 oz (165 g) with batteries.
