null

Dynamic Cone Penetrometers (DCP)

Dynamic Cone Penetrometers (DCP)

A dynamic cone penetrometer (DCP) measures the in-place strength of pavement base, subbase and subgrade. A drop hammer drives a cone into the ground, and the penetration per blow is converted to CBR for the DCP test. Choose dual-mass models made to ASTM D6951 for CBR 0.5 to 100, single-mass kits for firmer soils, or Sowers-style sets for foundation testing in augered holes. You can also shop hammers, extension rods and disposable cones. For shallow checks, see pocket penetrometers or browse all soil penetrometers.

ACCURATE
RELIABLE Testing You Can Trust
ASTM
QUALITY Trusted Brands
WIDE RANGE
WIDE RANGE Testing Equipment & Supplies
Dynamic Cone Penetrometers (DCP)

DCP Test Equipment for Pavement and Foundation Soils

The dynamic cone penetrometer test is a fast, low-cost way to check soil strength in place. It was developed by the U.S. Army Corps of Engineers and is standardized in ASTM D6951. In the standard DCP test, an 8kg hammer falls 575mm onto an anvil and drives a 20mm, 60° cone into the ground. You record the depth after each blow, then use the rate of penetration to estimate CBR and track changes between layers.

Dual-Mass and Single-Mass DCPs

A dual-mass DCP switches between an 8kg and a 4.6kg hammer to cover CBR 0.5 to 100, and the light hammer gives better results in weak soils. A single-mass DCP uses only the 8kg hammer for CBR 10 to 100, which suits occasional testing where very weak soils are rare.

Sowers-Style and Automated DCPs

A Sowers-style DCP drops a 15 lb hammer 20in to drive a 1.5in, 45° cone in the bottom of a hand-augered hole, and its blow counts are correlated with SPT results for foundation work. For automated recording, the Vertek SmartDCP counts blows and logs depth to a phone or tablet.

DCP Accessories

Extension rods let you test to about 6ft. Hardened, reusable points and disposable cones with adapters are available for soils where the cone is hard to extract. Drive tube heads and 3 x 10in sampling tubes collect undisturbed samples.

Where the DCP Test Is Used

The DCP test is used for pavement design and construction quality control, subgrade and base course evaluation, and shallow foundation investigations.

Pair your DCP with field density test equipment, or compare static cone penetrometers for soft, fine-grained soils.

[]